FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits

DpX4 Simulation

Elad0708
Employee
388 Views

I Created design based on DPX4 5.4GHz. The example design includes 'dp_gxb_sysclk' module. According to Ip generation the reference clock supposed to be 150Mhz. I created simulation based on this design and it seems that the pll doesn't lock and no ref_clock or sys_clock is driven at the pll outputs. I will appricate If I can get help on this subject. 

The device is Aglilex-7. 

 

Best Regards,

Elad Rotem 

 

Labels (1)
0 Kudos
7 Replies
Farabi
Employee
311 Views

Hello,


We will look into your PLL setting first.

  1. Do you have design example we can check your PLL parameters?
  2. If you reduce the output clock speed- can it lock?


possible cause PLL wont lock:

a. VCC to PLL not stable - need to capture scope shot

b. unstable refclk - need to capture scopeshot

c. PLL reset signal triggered - need to check schematic


regards,

Farabi



0 Kudos
Elad0708
Employee
276 Views

Hi Farabi, 

Thank you for your response. The model I have issue is simulation and not lab test. 

In simulation the pll doesn't lock or drive any clock at his outputs. 

Regards,

Elad 

0 Kudos
AqidAyman_Intel
Employee
201 Views

Hello,


May I know which example design that you are referring to? Can you pointed out to us?


Regards,

Aqid


0 Kudos
Elad0708
Employee
160 Views

DisplayPort using Agilex-7 Device. 

Elad 

0 Kudos
AqidAyman_Intel
Employee
106 Views

Hi Elad,


Is this from the IP simulation example itself as link below?

https://www.intel.com/content/www/us/en/docs/programmable/683273/23-3-20-0-1/simulation-example.html


It will be helpful if you can share the link pointing to the design that you mentioned.


Regards,

Aqid


0 Kudos
Elad0708
Employee
96 Views

Hi Aqid, 

The link you mention is for Arria V, Cyclone V, and Stratix V. I don't see any support for Agilex-7. Also, it only supports Modelsim. 

I created the DisplayPort IP from the Quartus and then press on 'create example design'. 

Regards,

Elad 

0 Kudos
ventt
Employee
58 Views

Hi Elad,


Are you following the steps outlined in Section 1.3 of the User Guide below to generate the Design Example for the DisplayPort Intel FPGA IP?


Please note that in this release, simulation is not yet supported for Agilex™ 7 F-Tile devices.


F-Tile DisplayPort Intel® FPGA IP Design Example User Guide


Thanks.

Best Regards,

Ven



0 Kudos
Reply