topic VTune installation problem in Analyzers

VTune installation problem

Huang_J_ — Sat, 13 Dec 2014 19:28:12 GMT

HI, when I'm installing VTune 2013 update 17, at the last step, an error log appeared shown below:

Warning: no sep3_15 driver was found loaded in the kernel.
Checking for PMU arbitration service (PAX) ... not detected.
Attempting to start PAX service ...
Executing: insmod ./pax/pax-x32_64-3.13.0-32-genericsmp.ko
insmod: error inserting './pax/pax-x32_64-3.13.0-32-genericsmp.ko': -1 Unknown symbol in module

Error: pax driver failed to load!

You may need to build pax driver for your kernel.
Please see the pax driver README for instructions.

Error: failed to start or connect to required PAX service

Can anyone help me out? Many thanks.

Besides, if I run in /sepdk

Huang_J_ — Sat, 13 Dec 2014 20:07:00 GMT

Besides, I run the following command in /sepdk/src:

lsmod | grep pax

lsmod | grep sep

lsmod | grep vtsspp

I can not see anything.

You need to go vtune/sepdk

Peter_W_Intel — Mon, 15 Dec 2014 03:28:02 GMT

You need to go vtune/sepdk/src, run (if you have Linux* kernel source installed.)

build-driver

insmod-sep3

However, I strongly suggest you to use latest VTune(TM) Amplifier XE 2015 u1 - since your kernel 3.13.0-32- is for latest OS, you need latest VTune to support latest OS.

HI, Peter, thanks for your

Huang_J_ — Mon, 15 Dec 2014 19:17:31 GMT

HI, Peter, thanks for your patience and response. I installed the latest VTune and problem solved.

Sounds good, thanks for the

Peter_W_Intel — Tue, 16 Dec 2014 07:08:48 GMT

Sounds good, thanks for the update.