https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883196#M3494 <P>That was the general idea I was getting from the documentation Ive been reading.</P> <P>Thank you for confirming it.</P> <P></P><FONT></FONT> Sun, 25 May 2008 21:06:33 GMT hippocrat 2008-05-25T21:06:33Z https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883194#M3492 <P>if I disable the on board NIC and used a PCI or usb NIC can I still perform remote configuration ? </P> <P>I have searched the forum and found similar subjects but most are concerning the use of multiple NICs not an alternative to the on board controller .. </P> <P>Thanks in advance. </P> <P></P> Sat, 24 May 2008 23:12:55 GMT https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883194#M3492 hippocrat 2008-05-24T23:12:55Z https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883195#M3493 <P>Unfortunately, if you disable the on board NIC you will lose the remote configuration ability... as mentiond in the vPro FAQ: <A href="https://community.intel.com/en-us/articles/article_nice_name">http://software.intel.com/en-us/articles/intel-vprot-technology-faq</A></P> <BLOCKQUOTE dir="ltr"> <P>"Intel AMT communicates only through the onboard network interface of Intel vPro technology"</P></BLOCKQUOTE> Sun, 25 May 2008 13:42:17 GMT https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883195#M3493 DAN_A_Intel 2008-05-25T13:42:17Z https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883196#M3494 <P>That was the general idea I was getting from the documentation Ive been reading.</P> <P>Thank you for confirming it.</P> <P></P><FONT></FONT> Sun, 25 May 2008 21:06:33 GMT https://community.intel.com/t5/Intel-Business-Client-Software/Basic-question-about-AMT/m-p/883196#M3494 hippocrat 2008-05-25T21:06:33Z