topic AMT Outpost as Windows Service Problem in Intel® Business Client Software Development

AMT Outpost as Windows Service Problem

mdyetik — Sun, 10 May 2009 17:23:25 GMT

hii everybody,

I am connecting an AMT client machine by "Manageability Terminal Tool.exe" and I want to use serial over lan (SOL) features. To use all off the features of SOL, the client machine should run "Manageability Outpost Tool.exe" windows program. Is it necassary? and it seems bad, because I think client user shouldn't notice that his machine is managed by SOL.

so I use "Manageability Outpost Service Control Panel Tool.exe" and I install the outpost as a windows service. and I set up settings. everything goes fine except one thing. this time, when I run any program like ("exec notepad"), the client AMT machine runs target program but doesnt show graphical user interface (GUI). thats I can see the new running program in windows taskmanager (exactly in processors tab), but the client user doesnt see the new started programs.

the new programs starts to run at the client pc with corect user privileges. I controlled it. but, maybe, the parent ID of the programs aren't "explorer.exe"?? may it be? client user cannot see GUI of them? What about you? What do you think?

( all of programs are part of Manageability Developer Tool Kit - v. 0.6.09037.2 )

Re: AMT Outpost as Windows Service Problem

Gael_H_Intel — Mon, 11 May 2009 22:12:17 GMT

Quoting - mdyetik

Hi - I have forwarded your question to the DTK folks.

Re: AMT Outpost as Windows Service Problem

mdyetik — Wed, 13 May 2009 04:55:32 GMT

Quoting - Gael Holmes (Intel)

Hi - I have forwarded your question to the DTK folks.

@Mrs. Gael Holmes,

Have I written this question in wrong forum? Is there any forum that DTK folks directly read? If so, I will write my next questions in that forum.

Re: AMT Outpost as Windows Service Problem

Gael_H_Intel — Wed, 13 May 2009 15:21:28 GMT

Quoting - mdyetik

@Mrs. Gael Holmes,

Have I written this question in wrong forum? Is there any forum that DTK folks directly read? If so, I will write my next questions in that forum.

We usually direct DTK questions such as yours to the DTK team. You might try submitting your question to the following email address: Support_DOPD_SWE@intel.com. If you think you are looking at a bug, then there is a "bug-report.rtf" file in the doc folder in the DTK - just fill it out and send it to the above email address - you might get a quicker response doing this.

Our apologies for the confusion.