XL710 NVM Blank EEPROM Programming

idata — Fri, 10 Feb 2017 21:30:11 GMT

In the meantime, we were able to get our new board mostly working by taking an NVM eeprom chip off of an Intel X710-DA2 adapter we had.

We tried using nvmupdate64e on our blank eeprom, but it says "Access Error" (and yes, write protect is disabled).

- Are there other tools available to program the NVM when blank?

- Do we need a separate EEPROM programmer to program it breof ir goes on the board?

- Can it be programmed via JTAG? if so are there tools for that?

Thanks

Re: XL710 NVM Blank EEPROM Programming

CarlosAM_INTEL — Mon, 13 Feb 2017 14:42:22 GMT

Hello, ScottCarsley:

Thank you for contacting Intel Embedded Community.

It is important to let you know that the Intel(R) Ethernet Converged Network Adapter X710-DA2 consultations should be addressed to the https://communities.intel.com/community/wired Intel Wired Ethernet Forum Community.

We hope that this information may help you.

Best regards,

Carlos_A.

topic XL710 NVM Blank EEPROM Programming in Embedded Intel® Core™ Processors

XL710 NVM Blank EEPROM Programming

Re: XL710 NVM Blank EEPROM Programming