I want to get an eepromarmtool to configure the I210 NIC ID and mac address used by the arm platform

Jason2907 — Wed, 09 Aug 2023 05:46:08 GMT

My arm platform is jetson TX2 NX, using a WGI210AT chip, and now I can see that the network controller ID is Intel Corporation Device 1531 (rev 03)

Re: I want to get an eepromarmtool to configure the I210 NIC ID and mac address used by the arm plat

Diego_INTEL — Wed, 09 Aug 2023 21:22:29 GMT

Hello @Jason2907,

Thank you for contacting Intel Embedded Community.

You can look for the following documents in RDC.

https://www.intel.com/content/www/us/en/resources-documentation

#572162 - EEPROM Access Tool

#513655 - Intel® Ethernet Controller I210 and I211- AT Production NVM Images

You will need a Premier account in order to get access to these documents or you can ask for help to an Intel Sales Representative in any Intel Authorized Distributor Partner near your zone.

https://www.intel.com/content/www/us/en/support/articles/000058073/programs/resource-and-documentation-center.html

https://www.intel.com/content/www/us/en/partner/showcase/partner-directory/distributor.html#sort=relevancy

Best regards,

@Diego_INTEL

topic I want to get an eepromarmtool to configure the I210 NIC ID and mac address used by the arm platform in Embedded Connectivity

I want to get an eepromarmtool to configure the I210 NIC ID and mac address used by the arm platform

Re: I want to get an eepromarmtool to configure the I210 NIC ID and mac address used by the arm plat