E810_(EYE810XXVAM2) Initial flashing procedure

adithyan — Wed, 17 Apr 2024 06:11:59 GMT

Hi Team,

we are using intel e810 mac in our custom board , do we have any idea about below queries.

Required Ethernet Configuration : 2 x25G

1. Can we flash the firmware(spi flash) of e810 externally using external spi flasher like dediprogrammer ?We are planning to use sf100 flasher ?

2. If answer to question 1 is yes , which is the binary we need to use ,can you share the link or the file for the same ? Which is the binary we need to use for below configuration ?

3. Is there any offset on flashing the spi flash or we can start from address 0x00 ?

4. As we are using custom board , we have our own methods to flash the spi , so will flashing the spi alone will boots up the system with full functionalty ? If no can you tell us what is the steps we need to do ?

Note - We have validated the functionalty of e810 evk with our arm64 based processer Ampere ultra max.

Regards

Adithyan

Re: E810_(EYE810XXVAM2) Initial flashing procedure

Fikri_Intel — Thu, 18 Apr 2024 04:35:00 GMT

Hello @adithyan ,

Thank you for posting in Intel Communities.

We found that there are a few similar posts created by you.

However, you may continue to update/follow up on this below link:
https://community.intel.com/t5/Ethernet-Products/E810-EYE810XXVAM2-Initial-Flashing-Procedure/m-p/1588300#M37282

We will proceed to close this thread as a duplicate.

Regards,
Fikri_Intel

topic E810_(EYE810XXVAM2) Initial flashing procedure in Ethernet Products

E810_(EYE810XXVAM2) Initial flashing procedure

Re: E810_(EYE810XXVAM2) Initial flashing procedure