topic configure the triple speed ethernet register with verilog in Ethernet Products

configure the triple speed ethernet register with verilog

spha — Sat, 05 May 2018 08:24:51 GMT

Hello! I am using TSE(triple speed ethernet) ip core to implement communication bewteen my pc and the FPGA(cyclone IV). But I don't know how to configure the TSE register with verilog. I do read some information from the user guide. For example, here are from the user guide:

Base registers to configure the MAC function. At the minimum, you must

configure the following functions:

• Primary MAC address (mac_0/mac_1)

• Enable transmit and receive paths (TX_ENA and RX_ENA bits in the

command_config register)

But I don't know how to realize this configuration in my project with verilog.

Anything can be help!

Best wishes!

Re: configure the triple speed ethernet register with verilog

idata — Mon, 07 May 2018 05:00:41 GMT

Hi Siepha

Thank you for posting in Wired Communities. Further checking inquiries for Altera product should be supported by Altera support, you can contact them at https://www.altera.com/support/support-resources/intellectual-property/interface-protocols/triple-speed-ethernet/ips-inp-tse.html Triple-Speed Ethernet MegaCore Function Resource Center or you may go to https://www.altera.com, select Login or to create a new account, after the complete verification process (via email) you may use the Support section of Altera's website to create a Service Request.

Hope the above information help.

Regards,

Sharon T