https://community.intel.com/t5/Intel-Fortran-Compiler/input-conversion-error-Common-block/m-p/761636#M17123 I have a fortran code, written by somebody and he is not here.. There is common block in the code which is not being used anywhere in the code. So I wanted to remove the common block... But without the common block, the code gives a <BR /><BR />forrtl: severe (64): input conversion error,<BR />And the same code with the common block runs till convergence and all is fine. <BR /><BR />Yes I am reading some formatted not just at the beginning of the code but even while running the code..<BR /><BR />I want to know whats happening because I just want to confirm that the numbers its churning out are actually something that I wnat to see... I am not familiar with using debugger in linux environment hece... couldn't understand it myself..<BR /><BR />Thanks in advacne...<BR />Subbu. Wed, 04 May 2005 21:41:55 GMT winam 2005-05-04T21:41:55Z https://community.intel.com/t5/Intel-Fortran-Compiler/input-conversion-error-Common-block/m-p/761636#M17123 I have a fortran code, written by somebody and he is not here.. There is common block in the code which is not being used anywhere in the code. So I wanted to remove the common block... But without the common block, the code gives a <BR /><BR />forrtl: severe (64): input conversion error,<BR />And the same code with the common block runs till convergence and all is fine. <BR /><BR />Yes I am reading some formatted not just at the beginning of the code but even while running the code..<BR /><BR />I want to know whats happening because I just want to confirm that the numbers its churning out are actually something that I wnat to see... I am not familiar with using debugger in linux environment hece... couldn't understand it myself..<BR /><BR />Thanks in advacne...<BR />Subbu. Wed, 04 May 2005 21:41:55 GMT https://community.intel.com/t5/Intel-Fortran-Compiler/input-conversion-error-Common-block/m-p/761636#M17123 winam 2005-05-04T21:41:55Z