topic How do a make a Release configuration in Intel® Fortran Compiler

How do a make a Release configuration

davidgraham — Thu, 10 May 2012 14:43:55 GMT

I have always just had a Debug configuration but realise it would be better to issue a Release configuration to users.
I selected "Release" and tried to build but got an error as my include files were not found.

In Project Properties - Configuration Properties - Fortran - General - the Additional Include Directories is set up correctly.

What could be wrong?

Thanks,
David

How do a make a Release configuration

Steven_L_Intel1 — Thu, 10 May 2012 14:54:51 GMT

Are you sure the Additional Include Directories were properly set for the Release configuration? Normally, when you change project properties, the changes are only done for the configuration currently active.

How do a make a Release configuration

davidgraham — Thu, 10 May 2012 15:34:31 GMT

I think they are correct.
The .f90 files are in the project root directory, the include files are in subdirectories in that root. The 'Debug' directory is not in the Additional Include Directories statement.
David

How do a make a Release configuration

Steven_L_Intel1 — Thu, 10 May 2012 17:33:46 GMT

I think you need to provide more information. Can you attach the buildlog.htm and the .vfproj file?

How do a make a Release configuration

SergeyKostrov — Fri, 11 May 2012 03:09:03 GMT

Hi David,

Quoting davidgraham

You need to review project settings for the Release configuration. Some options, like Include or Libpaths, must be identical.

Best regards,
Sergey

How do a make a Release configuration

davidgraham — Fri, 11 May 2012 13:57:14 GMT

I have added the buildlog & project file.
Hope this helps.
David

How do a make a Release configuration

Steven_L_Intel1 — Fri, 11 May 2012 14:48:07 GMT

Your Include file settings are not the same across Debug and Release configuration:

Debug:
\DavidG\Grade\GradeSource\grade\gcb;\DavidG\Grade\GradeSource\grade\graphics;\DavidG\Grade\GradeSource\grade\iface

Release:
\DavidG\GradeSource\grade\gcb;\DavidG\GradeSource\grade\graphics;\DavidG\GradeSource\grade\iface

It looks to me as if you omitted one level of directory (\Grade\) for the Release setting.

How do a make a Release configuration

davidgraham — Mon, 14 May 2012 12:24:13 GMT

Thanks, I hadn't spotted that difference.
I am getting just a few errors with Seed, Random, DlgWnd2ID etc.
Iv'e looked at the differnce between the two configurations but can't see where the problem is.
I have attached the files again.
Thanks,
David

How do a make a Release configuration

Steven_L_Intel1 — Mon, 14 May 2012 15:14:12 GMT

You have /iface:cvf turned on in Release but not Debug. Turn it off in Release. This may solve some of the problems.

How do a make a Release configuration

davidgraham — Tue, 15 May 2012 08:43:42 GMT

Thanks, that was the problem.
David