topic lippvc error message in Intel® Integrated Performance Primitives

lippvc error message

cla-12345 — Sun, 12 Dec 2004 09:37:51 GMT

Greetings,

I'm trying to compile the IPP sample MPEG 2 encoder for Linux, and amreceiving the following error:

/usr/bin/ld: cannot find -lippvc

collect2: ld returned 1 exit status

I can barely spell "Linux", so any suggestions would be very much appreciated by this newbie.

Thanks!

Message Edited by CLA-12345@neb.rr.com on 12-11-2004 05:43 PM

Message Edited by CLA-12345@neb.rr.com on 12-11-2004 05:44 PM

Re: lippvc error message

Vladimir_Dudnik — Sat, 18 Dec 2004 01:45:15 GMT

it seems you use shared IPP libraries. If you trying to compile with evaluation version, please be noticed that evaluation version does not contain shared libraries.

Regards,

Vladimir

Re: lippvc error message

cla-12345 — Sat, 18 Dec 2004 02:47:23 GMT

Hi Vladimir,

Thanks for the reply. I am using the non-commercial version of the IPP, rather than the evaluation version. Based on the following information from theNon-Commercial FAQon Intel's web site (see link below), it was my understanding that itis a complete package. Is that not correct? Thanks again!

"Q. Do the features vary between the non-commercial and commercial product?
A. At the current time, the non-commercial product offerings have the same features as the commercial product. However, Intel reserves the right to change this policy without notice at any time. In addition, the licenses provided include limited support and are not renewable."

http://www.intel.com/software/products/noncom/faq.htm

Re: lippvc error message

Vladimir_Dudnik — Sat, 18 Dec 2004 03:45:50 GMT

non-commercial version should include shared libraries. Actually, you can easely check this, right? So, probably the problem is in Makefile you are using. It seems for me that the path to library was set in wrong place. Can you verify that?

Vladimir