USB Host Side Software + USB H/W Interface

arfan — Fri, 02 Jul 2004 21:07:41 GMT

Dear Developers,

What should I have to do to manipulate the USB protocol packets on the host side of the system.

If I have to give a USB H/W interface to my Microcontroller then do I have to install the whole USB bus if I only require one port only.

Regards,

Arfan

Re: USB Host Side Software + USB H/W Interface

Intel_Software_Netw1 — Sat, 18 Sep 2004 06:16:17 GMT

This is somewhat outside the scope of what is supported here.You might try contactingIntel Microcontroller support via the form linked from:http://support.intel.com/design/support/faq/microcontrollers/support_disclaimer.htm

For hardware design assistance, the best option is usually towork withan Intel Product Representative. If your company has its own Intel representative, you may wish to inquire whether they are able to assist with this inquiry. Your company's Purchasing Department will normally have your Intel representative's contact information. If you have no contact, please see http://www.intel.com/buy/wtb/wtb1023.htm under "Design Help".

If your location is not listed, please see an Intel Authorized Distributor and ask for a Field Application Engineer (FAE). Our Intel Authorized Distributor list is also linked from the URL above.

Regards,

Lexi S.

IntelSoftware NetworkSupport

http://www.intel.com/software

Message Edited by intel.software.network.support on 12-02-2005 08:54 PM

Software ArchiveのトピックRe: USB Host Side Software + USB H/W Interface

USB Host Side Software + USB H/W Interface

Re: USB Host Side Software + USB H/W Interface