FDC question

engg_neo — Wed, 10 Mar 2004 01:46:04 GMT

Hi all, i'm a new user here. I have a question related to programming the FDC using ports. I would like to know the exact steps to read and write data from a floppy drive. I have read the intel documentation for the 82077AA and find it quite good. however i could not understan if the initialization routine must be done before every command to the FDC or only once duing system startup? what else should i do each time i want to read a sector from the floppy.
Your help will be greatly appreciated.

Re: FDC question

Intel_Software_Netw1 — Sat, 20 Mar 2004 04:36:25 GMT

For access to any documentation not publicly posted at http://www.intel.com/design/archives/periphrl/, and for this type of design assistance, we recommend that you contact an Intel Product Representative.

If your company already has its own Intel representative, you may wish to inquire whether they are able to assist with this inquiry. Your company's Purchasing Department will normally have your Intel representative's contact information. If you have no contact, please see

http://www.intel.com/buy/wtb/wtb1023.htm under "Design Help".

If your location is not listed, please see an Intel Authorized Distributor and ask for a Field Application Engineer (FAE). Our Intel Authorized Distributor list is also linked from the URL above.

Regards,

Lexi S.

IntelSoftware NetworkSupport

http://www.intel.com/software

Message Edited by intel.software.network.support on 12-07-2005 04:19 PM

topic Re: FDC question in Software Archive

FDC question

Re: FDC question