topic Hello Matthias, in Software Archive

Devkit setup - wireless connection?

Conor_B_ — Thu, 17 Apr 2014 10:50:21 GMT

Hi guys,

I'm following the IoT Dev kit guide

https://software.intel.com/sites/default/files/managed/2a/e9/Intel-DeveKit-Tutorial-Guide.pdf

On page 7, it indicates to connect the host pc and the galileo to a router. I have a wireless internet connection, can you set it up without a wired connection?

Thanks

Conor

no time to put full details.

Matthias_H_Intel — Thu, 17 Apr 2014 11:10:49 GMT

no time to put full details. Just some hints:

- you obviously would need to have a wireless adapter attached to your Galileo board PCIe

- you'd have to configure for your wireless environment [connman configuration file]and make sure WiFi is enabled on startup (rfkill unblock -> dependent on which version of image you are running either init.d or systemd script)

Good luck,
Matthias

Hello Matthias,

Conor_B_ — Thu, 24 Apr 2014 09:22:14 GMT

Hello Matthias,

Thank you for your reply. I have my Galileo connected to Wifi with a wireless adapter.

To be honest, I am completely new to Linux and don't really know how to configure the wireless environment as you describe. If you had the time, I would really appreciate if you could perhaps post a "how to guide" of how to set up the IoT Dev kit guide with a wireless connection.

I'm sure it would benefit other people also who do not have a wired connection but would like to follow the IoT examples on the website.

Many thanks

Conor

I plan to write a blog in

Matthias_H_Intel — Fri, 25 Apr 2014 12:21:42 GMT

I plan to write a blog in near future. Pls grant me some more time to write it up

Hello Matthias,

Conor_B_ — Fri, 25 Apr 2014 12:56:00 GMT

Hello Matthias,

That would very very helpful.

Many thanks

Conor

Hello Conor and Matthias,

Stev — Thu, 01 May 2014 11:10:23 GMT

Hello Conor and Matthias,

Could you please post the instructions of how to set up the devkit with a wireless connection. It would be very help as I would like to use it but do not have access to a wired router as described in the getting started guide.

Cheers

Stev

Using a Serial terminal

KMill10 — Thu, 01 May 2014 15:16:13 GMT

Using a Serial terminal (PuTTY, TeraTerm etc) connected to the 3.5mm Jack you can follow the instructions on my blog at www.spider-e.com/wp for getting WiFi running on Galileo. Blog post is here.

You won't need to download anything as the drivers for some Intel cards are already in the IoT image.

Quote:matthias-hahn (Intel)

Matthias_H_Intel — Sat, 17 May 2014 22:10:00 GMT

matthias-hahn (Intel) wrote:

I plan to write a blog in near future. Pls grant me some more time to write it up

Kenny nicely described how to setup Intel® Galileo low level Yocto uses the connection manager connman which allows to configure wireless access at a higher level. Pls find my blog on that at https://software.intel.com/en-us/blogs/2014/04/25/wireless-galileo-on-yocto-linux-iot-devkit-image.