https://community.intel.com/t5/Intel-vPro-Platform/VPRO-SCOM-Management-Pack-Not-Showing-General-Settings/m-p/430538#M5403 <P>I have install the VPRO mangement Pack after provisioning through SCCM. I think have followed it to the letter via the installation guide. The only part that I left out that I didnt think was valid was the opening of ports for TLS. I have my firewall turned off so this should not involve this issue. The exact issue I ma having is in the Post Installation task where I need to set my Discovery Settings. When in SCOM and I go to Monitioring, Intel AMT Systems - Service Settings on the Center pain I should be seeing setting that I can edit. These are not visible. Anyone any ideas of what I have done wrong or what I need to do? Please help this is pretty urgent Many Thanks. C.</P> Wed, 28 Oct 2009 11:38:37 GMT idata 2009-10-28T11:38:37Z https://community.intel.com/t5/Intel-vPro-Platform/VPRO-SCOM-Management-Pack-Not-Showing-General-Settings/m-p/430538#M5403 <P>I have install the VPRO mangement Pack after provisioning through SCCM. I think have followed it to the letter via the installation guide. The only part that I left out that I didnt think was valid was the opening of ports for TLS. I have my firewall turned off so this should not involve this issue. The exact issue I ma having is in the Post Installation task where I need to set my Discovery Settings. When in SCOM and I go to Monitioring, Intel AMT Systems - Service Settings on the Center pain I should be seeing setting that I can edit. These are not visible. Anyone any ideas of what I have done wrong or what I need to do? Please help this is pretty urgent Many Thanks. C.</P> Wed, 28 Oct 2009 11:38:37 GMT https://community.intel.com/t5/Intel-vPro-Platform/VPRO-SCOM-Management-Pack-Not-Showing-General-Settings/m-p/430538#M5403 idata 2009-10-28T11:38:37Z