Embedded Connectivity
Intel network controllers, Firmware, and drivers support systems
845 Discussions

How to change the I210 in 1000M Mbps Full Duplex

ZisGe
New Contributor I
724 Views

I burn the image into the I210. And reset the power, I find it is running in 100M mode, not the 1000M.

---> igb 0000:01:00.0 eth1: igb: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX

 

How to set the 1000M full duplex??

 

0 Kudos
1 Solution
CarlosAM_INTEL
Moderator
619 Views

Hello, @ZisGe​:

 

Thank you for contacting Intel Embedded Community.

 

You should refer to the FSD Bits information stated in chapter 6.8.6.1, on page 234 of the Intel(R) Ethernet Controller I210 Datasheet document #333016 that can be found on the following website:

 

https://www.intel.com/content/www/us/en/embedded/products/networking/i210-ethernet-controller-datasheet.html

 

Best regards,

@Mæcenas_INTEL​.

View solution in original post

0 Kudos
2 Replies
CarlosAM_INTEL
Moderator
620 Views

Hello, @ZisGe​:

 

Thank you for contacting Intel Embedded Community.

 

You should refer to the FSD Bits information stated in chapter 6.8.6.1, on page 234 of the Intel(R) Ethernet Controller I210 Datasheet document #333016 that can be found on the following website:

 

https://www.intel.com/content/www/us/en/embedded/products/networking/i210-ethernet-controller-datasheet.html

 

Best regards,

@Mæcenas_INTEL​.

0 Kudos
ZisGe
New Contributor I
619 Views
0 Kudos
Reply