Configure both DDI ports as DP in ATOM E3826

[LShar2]

I'm want to know that can we configure both DDI ports of Intel ATOM E3826 as Display port simultaneously?

Is there limitation to this configuration?

As mentioned datasheet both can be configured as eDP at same time. Does this applies to HDMI and DP also?

[CarlosAM_INTEL]

Hello, Lalit_LFT:

Thank you for contacting Intel Embedded Community.

The information that may help you is stated in the last row of the table located on page 43 of the https://cdrdv2.intel.com/v1/dl/getContent/522355 Bay Trail Dashboad document # 522355.

It is accessible when you are logged into your Resource & Design Center (RDC) privileged account. It can be requested by filling out the https://www.intel.com/content/www/us/en/forms/design/contact-support.html RDC Account Support form.

We hope that this information may help you.

Best regards,

Carlos_A.

[LShar2]

Thank you Carlos for support.

[CarlosAM_INTEL]

Hello, Lalit_LFT :

Thanks for your reply.

You are welcome.

Please do not hesitate to contact us if you have any question related to Intel Embedded products.

Best regards,

Carlos_A.

[LShar2]

Hello Carlos,

As system is having MIPI CSI interface also, where can I find the material for MIPI CSI interface on ATOM E3826 processor.

I have gone through datasheet of the processor but I need more information for driver development of the CSI interface. Is there any additional inerface document or driver development guide available for CSI?

[CarlosAM_INTEL]

Hello, Lalit_LFT:

Thanks for your reply.

We suggest you review with the assistance of your BIOS vendor the information stated in section 5, on pages 28 and 29 of the https://cdrdv2.intel.com/v1/dl/getContent/526998 Bay Trail - I SoC BIOS Writer's Guide Addendum document # 526998.

This document is accessible when you are logged into your RDC privileged account as well.

We hope that this information may help you.

Best regards,

Carlos_A.