Embedded Intel Atom® Processors
Technological Conversations about Intel Atom® Hardware, Software, Firmware, Graphics

braswell hot-plug pcie

sbass
Beginner
1,879 Views

Hello,

In datasheet " 18.2.2.1 Express Card Hot-Plug Events":

A full Hot-plug Controller is not implemented.

Presence detection occurs when a PCI Express* device is plugged in and power is

supplied. The physical layer will detect the presence of the device, and the root port will

set the SLSTS.PDS and SLSTS.PDC bits.

if only :

SLCAP --> Hot-Plug Capable (HPC) & Hot-Plug Surprise (HPS) is set.

SLCTL_SLSTS --> Hot-Plug Interrupt Enable (HPE) & Presence Detect Changed Enable (PDE) is set

SLSTS.PDS and SLSTS.PDC is set when detection ?

But training pcie is executed while detection or we must launch manually training ?

In my case, i have fpga already connected, but not loaded with firmware. i can use hot plug detection, when fpga loaded ?

i tested:

set CLIST_XCAP.SI = 1

1/ check before load fpga slsts.pds & slsts.pdc == 1

2/ load fpga

3/ check after , slsts.pds & slsts.pdc == 1

Why before load fpga pds = 1 ? how to working detection ?

Best Regards

Sébastien

0 Kudos
3 Replies
CarlosAM_INTEL
Moderator
588 Views

Hello, keziaha:

Thank you for contacting Intel Embedded Community.

In order to be on the same page, could you please tell me if this forum is related to the Carlos_A.

0 Kudos
sbass
Beginner
588 Views

hello,

yes, it is related to the braswell pcie training thread, but i create another thread because it' another way for resolve my problem.

2 ways:

- launch training manually after loaded fpga.

- activate hot-plug for discover after loaded fpga ( hot-plug launch automatically training ...).

Sorry for convenience.

Sebastien

0 Kudos
CarlosAM_INTEL
Moderator
588 Views

Hello, keziaha:

Thanks for your clarification.

For tracking proposes and in order to avoid duplicate efforts, we suggest you address this situation through the original thread (Carlos_A.

0 Kudos
Reply