Ethernet Products
Intel® Ethernet products and technologies
Announcements
Welcome to the Intel Community. If you get an answer you like, please mark it as an Accepted Solution to help others. Thank you!
3708 Discussions

About programming from I 210 to blank flash.

YKiku
Beginner
1,178 Views

It is a question when programming from I210 to a blank flash.

When programm to Flash of Blank using EepromAccessTool, "NVM_SI (pin12)" must be "pull down(Low)" with HW?

 

Using the "Flash of Blank using EepromAccessTool",

Is it possible to program from Blank Flash?

 

Tool Ver.:eepromaccesstool-0-7-6

0 Kudos
4 Replies
Daniel_D_Intel1
Employee
229 Views
Hello Ykiku, Thank you for posting in Intel Ethernet Communities. Please refer to the following thread, as it will be helpful: https://forums.intel.com/s/question/0D50P00004905mESAQ/i210-with-an-external-flash? If you have further questions about programming the I210, please refer to the Embedded Community. If you have any other questions relating to the Ethernet Controller, please let us know. https://forums.intel.com/s/topic/0TO0P00000018NIWAY/embedded-products? Best regards, Daniel D Intel Customer Support Under Contract to Intel Corporation
Daniel_D_Intel1
Employee
229 Views
Hello Ykiku, Please let us know if you were able to find a solution in the Embedded Community. If you have any other questions please do not hesitate to ask. Best regards, Daniel D Intel Customer Support Under Contract to Intel Corporation
YKiku
Beginner
229 Views

Hello Daniel-san

 

Thank you for your reply.

I am asking customer support directly now.

Thank you.

Daniel_D_Intel1
Employee
229 Views
Hello Ykiku, Thank you for the reply. It seems our colleagues have referred you to the Resource and Design Center. Hopefully the design team can provide a solution. Let us know if you have any other questions. Best regards, Daniel D Intel Customer Support Under Contract to Intel Corporation
Reply