Guidance for I210IS flashing for SGMII interface to external PHY.

[Venkat_M]

Hi Intel Team,

We are designing a custom board using Intel 11th Gen Core processor based SBC where we are using WGI210IS S  LJXX for SGMII output, The SGMII output is fed to Texas Instruments' DP83867 Phy IC for ethernet Output.. Please guide us in programming the I210S for SGMII output.

We have some queries :

1)  Can you please guide us which tool to be used LANconfig or EEUPDATE tool for SGMII output?

2) We need to flash bin file or a invm file (TXT file) for the SGMII output.

3) Can you specify which bin file or TXT file to be used.

Your prompt response would be appreciated.

Thanks & Regards,

Venkat.

[Azhari_Intel]

Hi Venkat_M,

Thank you for reaching out to us in the community.

As custom board is used, kindly to post your query on the Embedded Connectivity Forum for further assistance.

Do refer on the link below on the forum link mentioned to post your query.

https://community.intel.com/t5/Embedded-Connectivity/bd-p/embedded-networking-connectivity

Regards,

Azhari_Intel

[CarlosAM_INTEL]

Hello,  @Azhari_Intel:

Thank you for contacting Intel Embedded Community.

We need to clarify that this forum is related to the Intel® Ethernet Controller I210.

Due to this, the customer request is out of our scope of support.

Please consider this information when you provide the previous suggestion, or transfer any forums to the channel that you mentioned in your previous communication.

Best regards,

@CarlosAM_INTEL.