Community
cancel
Showing results for 
Search instead for 
Did you mean: 
RPand8
Beginner
494 Views

I am using 10G Intel card. Looking at product document it says 10Base-KR is supported. Basically i have connected 10G to xilinx development board using SFI interface and need to validate xilinx 10G-Base-KR IP. How to enable base-kr in intel NIC?

Enabling autoneg using ethtool is throwing error- -EINVAL

sudo ethtool -s ens4 speed 10000 duplex full advertise 0x1000 autoneg on

 

My requirement is to enable 10G-Base-KR in 82599ES 10-Gigabit SFI/SFP+ Intel NIC.

 

Ethernet controller: Intel Corporation 82599ES 10-Gigabit SFI/SFP+ Network Connection (rev 01)

0 Kudos
6 Replies
Michael_L_Intel2
Moderator
61 Views

Hello RPand8, Thank you for posting in Intel Ethernet Communities. To further check this issue, please provide the following details: 1. What is your OS? 2. What is the driver version installed? 3. Please provide the error in ethool. If you have questions, please let us know. Best regards, Michael L. Intel Customer Support Under Contract to Intel Corporation
RPand8
Beginner
61 Views

Thanks for the response.

My OS is: Linux radheys41 4.4.0-93-generic #116-Ubuntu SMP Fri Aug 11 21:17:51 UTC 2017 x86_64 x86_64 x86_64 GNU/Linux

I upgraded the driver to ixgbe-5.5.5.

 

Adding print in ixgbe_set_settings shows that we are returning EINVAL when autoneg is enabled.

 

if ((ecmd->autoneg == AUTONEG_ENABLE) ||

          (ecmd->advertising != ADVERTISED_10000baseT_Full) ||

          (speed + ecmd->duplex != SPEED_10000 + DUPLEX_FULL)){

            printk(KERN_ERR "Set link invalid \n");

            return -EINVAL;

        }

    }

 

Thanks,

Radhey

Michael_L_Intel2
Moderator
61 Views

Hello RPand8, We need to further check this inquiry. Please wait for our update regarding this one. If you have questions, please let us know. Best regards, Michael L. Intel Customer Support Under Contract to Intel Corporation
Michael_L_Intel2
Moderator
61 Views

Hello RPand8, While we are checking this issue, we would like to request for the complete markings of the NIC. Kindly send a photo on both sides of the card with clear markings. If you have questions, please let us know. Best regards, Michael L. Intel Customer Support Under Contract to Intel Corporation
Michael_L_Intel2
Moderator
61 Views

Hello RPand8, I just want to make a follow up on the markings of the NIC. Please send a photo of the NIC on both sides with clear markings. If you have questions, please let us know. Best regards, Michael L. Intel Customer Support Under Contract to Intel Corporation
Michael_L_Intel2
Moderator
61 Views

Hello RPand8, Just sending another follow up on the photo of the unit focusing on the markings. If you have questions, please let us know. Best regards, Michael L. Intel Customer Support Under Contract to Intel Corporation
Reply