Ethernet Products
Determine ramifications of Intel® Ethernet products and technologies
4859 Discussions

I218-V and I219-V LED Status

DShar9
Beginner
‎01-21-2016 04:50 AM
1,481 Views

I am currently using two separate boards with integrated I218-V and I219-V network adapters, hard wired through CAT6 cables to a switch.

When the I219-V machine is in S4/S5 sleep the link LED on the adapter and switch turn off.

When the I218-V machine is in S4/S5 sleep the link LED on the adapter and switch remain on.

 

Both adapters are configured with WOL disabled in the UEFI and also windows. The I218-V also continues showing a link if ErP is enabled. For my setup it is important to be able to tell the machines status by the light on the switch which is located in a separate room.

 

Any suggestions on why the two adapters are behaving differently, and how to configure them to behave in the same way?

 

0 Kudos

Link Copied

1 Reply
st4
New Contributor III
‎01-25-2016 01:09 AM
585 Views

Hi ds4130,

Thank you for the post. It is recommended to contact the board vendor which integrated the ethernet controller on the system.

rgds,

wb

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.