- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, recently I am running switchml P4 code on Tofino programmable switch (the code can be found in GITHUB), currently I am using version 9.7.4 of sde, during the compilation process there is an internal compiler error, the log message only shows some WARNING and no other ERROR, and I also asked the question in the official P4 forum, but the reply said the problem would be different depending on the compiler version, and the specific problem might be the P4 code writing, but there is no specific book about the problem, so I would like to seek an answer, thank you very much!
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kakos,
Thank you for reaching Intel Technical Support, As for your question regarding Intel Tofino, it more suit for you to post it at the Embedded Ethernet Communities as the product belong to that section. You can click on the link below for the Embedded forum and post your question there. Sorry for the inconveniences.
https://community.intel.com/t5/Embedded-Connectivity/bd-p/embedded-networking-connectivity
Regards,
Shaq_Intel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello, have you figured it out?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page