Ethernet Products
Determine ramifications of Intel® Ethernet products and technologies
4813 Discussions

implementation of network bonding

AJ6
Beginner
1,460 Views

hi every one

I am using i210 pcie to ethernet chip i am using a pcie switch between intel i7 processor and ethernet controller i210 i have two such controller connected to the pcie switch i was trying to do network bonding or teaming between the two links how to do this i tried this in RHEL but i am unable to do when i remove one link link between the end device is totally failing how to implement this with two links connected to a network switch

0 Kudos
1 Reply
SYeo3
Valued Contributor I
371 Views

Dear AGXIN.XAVIER,

Thank you for contacting Intel.

Please refer to the link below to configure Channel Bonding:

http://www.intel.com/support/network/sb/cs-009747.htm Network Connectivity — How Do I Use Teaming with Intel® Advanced Network Services (Intel® ANS)?

- look for Linux Ethernet Bonding

If you still encounter the same issue, please provide us the details below:

1. Operating System and version:

2. Driver version:

3. Teaming/bonding mode:

4. Steps on how you configure channel bonding

5. Error messages

Hope this helps.

Sincerely,

Sandy

0 Kudos
Reply