Ethernet Products
Intel® Ethernet products and technologies
Announcements
This community is designed for sharing of public information. Please do not share Intel or third-party confidential information here.
3923 Discussions

iscsi remote boot + ip

idata
Community Manager
1,110 Views

I configured iscsi remote boot in the X520-DA controller with ip 10.13.2.1 as initiator ip.

This works fine so far, however, while the ip does show up in windows as assigned to the controller when i check with ipconfig /all, its not assigned to the properties of ipv4 of the connection (GUI).

Anyone here with iscsi remote boot experience? I just add the ip static in the ip v4 properties of the connection and all is fine? Would I use a different ip for the boot process?

0 Kudos
1 Reply
Mark_H_Intel
Employee
236 Views

As you have discovered, configuring a static IP address for the iSCSI boot process will only be used for the operation of the iSCSI initiator. Once the OS is booted, then the normal OS IP configuration takes over. So, if you are using static addresses, you will need to configure the address separately for the initiator and for the operating system.

Mark H

Reply