1G/10Gbps Ethernet PHY IP Core can't work for 1Gbps rate transmission

FPGA Intellectual Property

PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP

1G/10Gbps Ethernet PHY IP Core can't work for 1Gbps rate transmission

913 Views

Hello guys,

I encountered a problem that I can't use the 1G/10Gbps Ethernet PHY IP Core for 1Gbps rate transmission. I use loopback mode. When I set this core "SEQ Force Mode" register as 10GBASE-R, I can transmit and receive data correctly under 10Gbps rate. But when I set it as GigE, this core fail. From logic analyzer I found the signals have been sent to the input data port "gmii_tx_d", but I can't get any signals on output port "gmii_rx_d".

Does anyone run into the same problem? Please give me some clue or advice.

Thanks

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.