Cannot upgrade PLL IP

[PDone]

I am trying to run IP that I am using is upgraded.the IP Upgrade Tool. Most of the IP that I am using upgrades, but PLL Intel FPGA v!*.1 does not.

When I create an instance of the PLL using the Megawizard plug in, it works fine and it shows up in the Hierarchy listing  and the IP Components listing.  When I click on the instance, it does not open the Megawizerd and says that

PLL Intel FPGA v18.1 could not be found in the specified library path

Other IP does open the Megawizard.

What is the issue?

[Ash_R_Intel]

Recommend you to follow the workaround mentioned in below link. It is known to work for v18.1.

https://www.intel.com/content/altera-www/global/en_us/index/support/support-resources/knowledge-base/component/2018/failed-to-launch-megawizard-plug-in-manager--pll-intel-fpga-ip-v.html

Regards.

[PDone]

THX.  I also have the same problem with the Altera Unique Chip ID.  what file should I modify?

[Ash_R_Intel]

Hi Peter,

Please try out this solution provided in this article:

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/ip/2018/failed-to-launch-megawizard-plug-in-manager--altera-unique-chip-.html?wapkw=unique%20chip%20ID

Please note that Chip ID IP is supported for following devices only:

Stratix 10

Arria 10

Cyclone 10 GX

MAX 10

Stratix V

Arria V

Cyclone V

Additionally you can follow Chip ID Intel FPGA IP Cores User Guide

Regards.