Change the default mode of 1G/10G PHY-IP

[MTwee]

Hi, I'm using 1G/10G PHY IP in my design. After power-up the IP is wake up by default in 10G mode. switching to 1G mode is done by reconfiguration of the IP (using Transciever Reconfiguration Controller). My question is how can I change the behavior so that after power up the IP would be wake up in 1G mode?

[Deshi_Intel]

HI MTwee,

Unfortunately no. BY default the IP is configured to start with 10G first then to be reconfigure to desired data rate.

Thanks.

[MTwee]

O.K,

Thanks for your answer.

regards,

Moshe