Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Valued Contributor III
726 Views

Device Does Not Show in Signal Compiler

Hi, 

 

When I click Scan Jtag in Signal Compiler, USB-Blaster shows up on the left, but the device (EP3C120) does not show up next to it. The same thing happens in SignalTap. 

 

This problem appeared after I (successfully) programmed the flash device with the .pof file for my design. After I restored the factory design, the problem remained even though the pattern of flashing LEDs seems to indicate that the factory design is restored. I'm using Matlab R2009a with DSP Builder 11.0. 

 

Any help would be greatly appreciated! 

 

Thank you, 

RUSHALE
0 Kudos
1 Reply
Highlighted
Valued Contributor III
5 Views

Re: Device Does Not Show in Signal Compiler

Hi, 

 

I closed that Matlab window and opened it again, and I also pressed the CPU_reset button. I'm not sure which solved the problem (probably the former), but its gone. 

 

Best Regards, 

RUSHALE
0 Kudos