- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,I configured the E-Tile Transceiver PHY Agilex7 IP ; and the Transceiver configuration rules is Gearbox 64/66 ;mode is TX/RX Duplex. TX and RX PMA data rate is 10312.5Mhz; PMA reference clock freq is 156.25Mhz. but generate the HDL ,the .v hssi_ehip_lane_ehip_rate parameter is "rate_25gx1",not "rate_10gx1". When connecting to a 10g network, the receiver of the other party cann't receive right data.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for reaching out to Altera Community Forum. Please be informed that the SME in this area is currently Out of Office. Expected to resume work on 30-Dec'24. We apologize for any delay in response and appreciate your patience and understanding.
Kind regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi,
Could you help me for my question?
Thank you very much,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, It's January 6th. Have they started to work?
Thanks,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Mel_tong,
Apologized for the delayed response.
May I know what's the protocol set in Eth Hard IP? Is it 10G/25G?
Regards,
Pavee

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page