[HDMI-IP] Cyclone 10 -> only FRL=0 available? HDMI v2.x not supported?

[amildm]

Hi All,

I'm using the Intel HDMI-IP in Cyclone-10 (Quartus v19.3). Does the IP support HDMI v2.x ? According to the page #4, the FRL is available for Arria-10 only.

Here is from UG page4 of the IP:

-----------------------------------------------------------------------------------------

Device Family: Supports Intel Stratix® 10 (H-tile and L-tile), Intel Arria 10,
Intel Cyclone® 10 GX, Arria V, and Stratix V FPGA devices
Note: HDMI 2.1 with FRL enabled supports only Intel Arria-10 devices.

-----------------------------------------------------------------------------------------

Thank you!

[ZH_Intel · Accepted solution]

Hi amildm,

Good day.

Yes you are correct.

HDMI IP does support HDMI 2.1(FRL) but the final support is only for Arria 10 device.

I'm afraid Cyclone 10 does not support HDMI 2.1 at the moment.

You may refer to below link for more information:

HDMI Intel® FPGA IP User Guide - 2.3. Feature Support 

Thank you.

Best Regards,

ZulsyafiqH_Intel

[ZH_Intel]

Hi amildm,

Good day.

I wish to follow up with you about this case.

Do you still have further inquiries on this issue?

Thank you.

Best Regards,

ZulsyafiqH_Intel

[ZH_Intel]

Hi amildm,

Good day.

I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread.

Thank you.

Best Regards,

ZulsyafiqH_Intel