FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6359 Discussions

Problem in DSP

Altera_Forum
Honored Contributor II
‎09-20-2012 10:18 AM
825 Views

I'm working with DSPF2812 and i have a problem . i'm doing PWM by comparing sinewave have 50 Hz and sowtooth 10 Khz but I can't use greater than 2 KHz for sawtooth where when i used greater than it the output square pulse didn't have 50 Hz..... why? 

 

i wuld like to tell you i'm using matlab2006a simulink to perform block of PWM and code composer V3.1. 

thanks alot
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎09-20-2012 12:19 PM
170 Views

I think you have this website confused with one run by TI.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.