Problems with the Test Pattern Generator

[Altera_Forum]

Hi, 

I'm trying to set up a Test Pattern Generator from the VIP. I'm using a Cyclone III Development Board with DVI adapter. My problem is, that the monitor shows no pattern. The resolution is 1680x1050. I used the following settings:  External PLL Clock: 119MHz  Hor Blank: 160px  Hor Sync: 32px  Hor Front Porch: 48px  Hor Back Porch: 80px  Ver Blank: 30lines  Ver Sync: 6lines  Ver Front Porch: 3lines  Ver Back porch: 21lines I take a few pictures and attached them to my post.  Hope somebody can help me.  Thank you!

[Altera_Forum]

Hello again, 

in the meantime, i tried another system unseccesfully. In Qsys I took a Clocked Video Input and gave it on a Clocked Video Output, so that i get a loop through. For the settings I take the DVI 1080p60 presets. The Video Clock comes from a PLL and the System Clock is 125MHz from Y4. Anyway I don't get any picture out of my DVI port =( Besides I measured with a scope at measuring point V on the Bitec DVI Card. On the input site, I could see a vertical sync signal. On the output site was nothing... Now I thing that I have overlook something on the board.  Thanks for help!