- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I want to use the RS232 UART (altera_up_avalon_rs232) IP in a project. But, I cannot find the definition of signals for this IP.
I need the exact definitions of byteenable, chipselect, address, read, write, irq, … signals of this IP from the right document.
Thanks in advance,
SAA
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you're talking about the IP in Platform Designer, it is discussed in the Embedded Peripherals IP user guide. The interface is standard Avalon memory-mapped described here: https://www.intel.com/content/www/us/en/docs/programmable/683091/20-1/introduction-to-the-interface-....
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page