- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI friends
I would like to know if there are any example design for tri speed ethernet mac without the usage of Qsys system intergration tool for MAX 10 CPLD.
I would like to know how to configure MAC address in tri speed ethernet mac ip in 10/100 small mac variation. In the IP user guide on page 81 it is mentioned that Base configuration register is not available 10/100 small mac variation.
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The small mac variation consist of base configuration register, and the MAC address can configure at address 0x03 and 0x04.
The note (1) in page 81 is referring to offset address 0x01 "scratch (1)" register Not the whole table 35.
Regards -SK Lim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Lim
I would like to know if there is any example design for 10/100 available for download without the use of the QSYS IP intergration tool available.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I don't see there is a similar design for the small mac MAX 10 device.
Regards -SK Lim
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page