FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6359 Discussions

Transceiver Phy output on Putty Terminal

matif
Novice
‎05-29-2019 11:04 AM
723 Views

Hi,

I have simulated my altera transceiver custom phy ip in modelsim and it is simulated well and fine. Now I want to see the output on putty terminal because I connected the received data to LEDS but the LEDS are blinking too fast so I cannot see anything. Is there any way to see transceiver received data on putty terminal? What do I do to see the received data on putty terminal​

0 Kudos

Link Copied

1 Reply
Nathan_R_Intel
Employee
‎07-01-2019 06:10 AM
378 Views
Hie, My apologies for the delayed response as i had a few cases titled Transceiver Phy output, hence I assumed I have answered this case. Intel FPGA does not offer a putty terminal to observe the signals or nodes in the FPGA fabric. Instead, if you just want to observe, please use the Signaltap Tool provided with our Quartus Prime software. You can observe the receiver parallel data using signaltap. Please check more details on Signaltap in the following link: https://www.youtube.com/watch?v=DCUhsezqydQ Regards, Nathan
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.