- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I just fired up our new custom board, and guess what, the network didn't start. And I am in a hurry. I have done a lot of work with phy's, but never via Nios. So could any of you gurus out there give me a few hint's? When running the SSS example, and disabling the DHCP, the server starts. The board is not connected to anything. But when I try to read from 0x200 it returns ffff. And no activity on signal tap. So: How to get all the debug messages turned on? And, has someone out there managed to get the loopback to work? I assume that the mac has been initialized since the server reports ok. I am about to start reading up on this, but it has been a while since I played with the fun stuff. Thanks, ApusLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page