FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6526 Discussions

in the document: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/archives/ug-altlvds-14.1.pdf, page 18

OLevy1
Beginner
‎07-21-2019 11:11 AM
514 Views

the configuration of 'What is the input data rate?' description is 'Specifies the data rate for the input channel of the receiver, in Mbps.' - my question is - i have 16 LVDS RX channels and the factor i am using is 4 (64b parallel bus). the data rate i need to use is for ONE Channel or for all 16 Channels together?

0 Kudos

Link Copied

1 Reply
SreekumarR_G_Intel
Employee
‎07-24-2019 06:43 AM
340 Views

data rate is you specified in the IP for one channel .

Note : I answer to your post already ; but somehow it is not appearing in the community window ;

 

Thank you ,

 

Regards.

Sree

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.