- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried to run a simple product with altera dsp builder advanced blocksets. then I compliled the project and program it on stratix IV board. when I set the data type to fixed point in dsp builder I can see the correct result in signal tap ii analyzer, but when I put the data type in single or double the output in signal tap ii will be zero!!
what is the problem? can anyone help me plz?Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does the design work in ModeSim simulation, for example using the DSP Builder > Verify Design UI? If not, do you have the design?

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page