simulate PCIe in Pipe mode

[dsun01]

Dear Intel Support/Expert, 

I have some problems while simulate AN829 in PIPE mode.  I am using Quartus 21.3, PCIe Gen3 8 line.  I can run in serial mode, but failed to run in PIPE mode. 

1. question. 

I noticed that at this link 

Design Example - PHY Interface for PCI Express (PIPE) - Intel Communities

it claimed that the PIPE only supports Gen1 and Gen2. is this true in the latest Quartus 21.3. if true, then ignore this post. if not please have a look at the attached file. it has detail description of the problem I have. 

thank you,

David

[Wincent_Altera · Accepted solution]

Hi David,

Yes, the example design only support Gen1 and Gen2.

I will proceed to close this case as per mention.

Regards,

Wei Chuan

[Wincent_Altera]

Hi

As your question been addressed.

Hence, This thread will be transitioned to community support.

If you have a new question, feel free to open a new thread to get support from Intel experts.

Otherwise, the community users will continue to help you on this thread. Thank you

If you feel your support experience was less than a 9 or 10,

please allow me to correct it before closing or let me know the cause so that I may improve your future support experience.

Regards,

Wincent_Intel