FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5355 Discussions

5CEBA4F17I7N surface anomalies

Leu
Beginner
404 Views

HI,

 

We purchased a batch of 5CEBA4F17I7N. When the part is put under magnification, we noticed the part surface looks pitted. With 200X magnification, the surface looks like pinhole voids. Wonder if it's possible to tell if a part is reworked by looking at the surface magnification? Or it's normal to see such observation on authentic brand new Altera part? 

 

Attached photos

Appreciate any advise. Thanks.  

0 Kudos
2 Replies
Zawani_M_Intel
Employee
338 Views

Hi Leu,

 

Thank you for contacting Intel FPGA Community Forum.

I am Wani who will support your issue.

 

Can I know who is your distributor? We can help to trace the lot history for your part.

 

Thanks! Stay safe and take care!

 

Regards,

Wani

Zawani_M_Intel
Employee
157 Views

Dear Leu,

 

We do not receive any response from you to the previous question/reply/answer that I have provided.

This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

 

Stay safe and take care!

 

Regards,

Wani

Reply