- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi when I use ADC at 20MHZ clock frequency there is offset comes means ADC is providing current to the board when I use 500KHZ it decreases how to correct it I want to use more sampling frequency
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Mohitgarg,
Is the "ADC" you mentioned the separate ADC device on DE-10 Nano or the ADC on FPGA?
Thanks & Regards,
Xiaoyan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Xiaoyan,
Its the adc in fpga LTC2308
Thanks & Regards
Mohit garg
Its the adc in fpga LTC2308
Thanks & Regards
Mohit garg
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Mohit garg,
I checked the User Manual of DE-10 Nano board. LTC2308 seems to be a general-use ADC.
According to your question, did you use it to test the system current or FPGA current? Or what is your usage with it?
Thanks & Regards,
Xiaoyan
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page