AIC23 / WM8731 audio codec noise problem

FPGA, SoC, And CPLD Boards And Kits

FPGA Evaluation and Development Kits

AIC23 / WM8731 audio codec noise problem

1,242 Views

Hello,

I am using the Cyclone II DSP Development Board. I want to test the audio codec (TLV320AIC23B) which is as far as I know from the programming point of view identically with the WM8731 codec.

For testing my VHDL code purpose, I just want to capture the line in input and send the data directly back to the DAC.

So far it works, but if I plug out the analog line in input, can hear a lot of noise. I already tried different transfer modes (DSP mode as slave and I2S mode as master).

If I transfer just zeros to the DAC the noise is gone. Of course there is some thermal noise involved, but this could hardly cause the strong noise, I got.

Any ideas?

Thanks,

Daniel

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.