FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5770 Discussions

ARRIA10 IBIS signal selection

APere81
Beginner
‎12-03-2019 01:09 AM
322 Views

I need to perform a Hyperlynx SI simulation between the ARRIA10 FPGA GXBL interface and a ADC. I've downloaded the arria10.ibs file, but I don't know what is the correct signal type to select for the TX and RX signals.

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.