FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6189 Discussions

Agilex 7 I-Series FM87 hardware rework for AD9081

bluncan
Beginner
631 Views

Hello,

 

I am trying to create a setup with an Agilex FM87 (dk-si-agib027fa) board and ADI AD9081. I looked over the FPGA's schematic and I saw that the board requires a hardware rework to support the AD9081. However, it is not exactly clear from the schematic what the hardware rework implies. I also saw that you have an interoperability report with a different Agilex and AD9081(https://www.intel.com/content/www/us/en/docs/programmable/709330/current/hardware-and-software-requirements.html) but it doesn't say anything about the rework either.

 

Could you give me some more information regarding that hardware rework?

 

Thank you!

 

Regards,

Bogdan

0 Kudos
2 Replies
Farabi
Employee
534 Views

Hello,


Apologies for late reply to you. Past few days was tracing the owner for this schematic and board design team. Just to update you currently we are tracing back the information down to board designer to get the information on the rework details. I will update you once we have the correct information.


regards,

Farabi


0 Kudos
Farabi
Employee
494 Views

Hello,


Thank you for your patience.

I have contacted you directly through email. I have send the rework instruction for your reference in that email.


I am closing this case now.


regards,

Farabi


0 Kudos
Reply