FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6196 Discussions

Arria 10 : Uboot Configuartion Settings

PJais1
Novice
899 Views

Hello,

I am building linux OS for our custom board which took reference from Arria 10 SoC .

I build u-boot image by taking reference from https://rocketboards.org/foswiki/Documentation/A10GSRDGeneratingUBootAndUBootDeviceTree

and boot from SD card https://rocketboards.org/foswiki/Documentation/A10GSRDCreatingAndUpdatingTheSDCardLTS

But the uboot is not booting when board is powered on.

As I am using custom board, i did changes in qsys file in quartus tool and generated .sof file according to our pin muxing at HPS side.

I am having a doubt that while generating uboot.mkpimage.img do we need to make changes in uboot-socfpga folder ? and if so, where do i modify these changes?

Thanks,

Priya

0 Kudos
4 Replies
EBERLAZARE_I_Intel
669 Views

Hi,

 

Did you replace the DDR module? If yes may I know the data sheet for the DDR that you are using?

 

Which quartus version or you using? Can you share the uboot log?

 

 

0 Kudos
EBERLAZARE_I_Intel
669 Views

Hi,

 

After getting the new generated sof files, the handoff folder will be generated as well according to the new compilation.

 

Thus, a new uboot img need to be made again by the "make uboot" command in SoC EDS based on the new generated handoff folder.

 

I hope this is clear.

0 Kudos
PJais1
Novice
669 Views

Hello,

 

Thanks for the help. I did the same earlier too. Actually, there was problem in DDR timing parameters , I have updated them in quartus tool, using DDR3 datasheet, and now uboot is sucsessfully build.

0 Kudos
EBERLAZARE_I_Intel
669 Views

Hi,

 

Thanks for the update and I apologize for any delay in my responses.

 

Let me know if more help needed.

 

0 Kudos
Reply