Arria 10 modelsimcalibration

[Chrisnu]

Hi,

I am trying to simulate Arria 10 DDR4 interface using Modelsim.I have run the simulation and it's passing. Now I am trying to run simulation with Calibration enabled.

Assuming that calibration completes successfully, am trying to understand how you get the changes that needs to be incorporated after Cal, from modelsim tool.

I am aware that, we can also do the calibration through EMIF debug tool, which generates a report. But not sure how do we get similar report from Modelsim.

Thanks,

Chris

[AdzimZM_Intel]

Hi Chris,

Thank you for submitting for question in Intel Community.

I'm Adzim, application engineer will assist you in this thread.

"I am aware that, we can also do the calibration through EMIF debug tool, which generates a report. But not sure how do we get similar report from Modelsim."

• This is unfortunate, we cannot generate a Calibration report from the simulation. It's can only be generated from the hardware test.

Regards,

Adzim

[Chrisnu]

Thanks Adzim,for clarifying.

Please share the procedure to run the calibration using hardware.

Regards,

[AdzimZM_Intel]

Hi Chris,

Please refer to Arria 10 EMIF Design Example User Guide.

Link: https://www.intel.com/content/www/us/en/docs/programmable/683842/21-1-19-2-0/design-example-quick-start-guide-for.html

There are a few video that you may watch for the guides:

• https://www.youtube.com/watch?v=vdAS1LVGPbI
• https://www.youtube.com/watch?v=UcxWM1eeqBs

Regards,

Adzim

[Chrisnu · Accepted solution]

Thanks Adzim!