- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Artix-7 XC7A100T-2CSG324I is used for the SPI configuration
with MT25QL256ABA8ESF-0SIT Flash.
I have used M[2:0]=001 during the programming.
Each time I try to program, erase, or read my attached
SPI flash I get:
Mfg ID : 0 Memory Type : 0 Memory Capacity : 0 Device
ID 1 : 0 Device ID 2 : 0
CRITICAL WARNING: [Labtools 27-2251] Unable to read the
device properties.
I have attached the details below. Any idea what might
be the issue?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am sorry, Artix 7 is not Intel FPGA product. please get consultation at Xilinx technical support.
regards,
Farabi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please be advised that due to the absence of a response from you regarding the previous notification we provided, we will be transitioning this thread to community support. If you have any new questions or concerns, we kindly suggest opening a new thread to receive assistance from Intel experts. However, if you do not have any further inquiries, the community users will be available to assist you on this thread. Thank you for your understanding

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page