The datasheet for the BD82QM77 Platform Controller Hub does not seem to specify whether the DisplayPort main links contain the termination resistors and Tx Vbias implemented on the die. Is this implemented in the physical layer or must the device be terminated externally?
I think you might have posted this thread into the wrong community forum. This forum only covers Intel FPGA product. Our agents can only help to provide assistance with regards to FPGA product. If you have further enquiries on other Intel product, please post your question to the correct Intel Community topics from the link below:
We will then require deleting this thread from the Intel FPGA forum topic.
Intel FPGA Support Team
I don't know how I ended up posting in this forum but you're absolutely right. Unfortunately when I try to delete the post I get the message:
"Your administrator has disabled cascaded deletions of feed post and comment."