- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can program my BeMicroSDK through the Bash shell however the programmer in Quartus (11.0) can no longer see the BeMicro SDK to program it.
It was working fine (Quartus programmer) until 20 minutes ago. Why?Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK I felt a bit annoyed but problem solved.
Not sure what I did.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
edited...
i don't have a BeMicro SDK, but i would start by uninstalling it in the Device Manager, removing it, then plugging it back in and reinstalling the driver- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry pancake... I was getting exasperated .... It was probably frustration at my lack of progress with the project overall.... I edited my last post....
I fiddled with the JTAG Chain debugger and hey presto it suddenly started operating again so.... I could see the programmer through the bash script, which was odd. Yeah and the tools are still a million times better than Codewarrior for any you who have 'been there'. :)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
edited my post likewise, though i was curious if you had a better experience elsewhere
the tools can require some head scratching, but they are definitely good enough to ship a product. i think this forum does a pretty amazing job of support - but there are limits to how much we can address without being on the inside anyhow glad you're back on track
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page